MSI 6741 DRIVER DOWNLOAD

Line In is used for external CD player, Tape player, or other audio devices. When adding or removing expansion cards, make sure that you unplug the power supply first. If you install two hard disks on cable, you must configure the second drive to Slave mode by setting its jumper. When you are installing the CPU, make sure the CPU has a heat sink and a cooling fan attached on the top to prevent overheating. You must configure second hard drive to Slave mode by setting the jumper accordingly. Hardware Setup Hardware Setup This chapter tells you how to install the CPU, memory modules, and expansion cards, as well as how to setup the jumpers on the mainboard. The connector location and pin assignments are as follows:

Uploader:	Juzil
Date Added:	17 September 2005
File Size:	56.7 Mb
Operating Systems:	Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads:	23022
Price:	Free* [*Free Regsitration Required]

Make sure to raise the lever up to a 90degree angle. Connect the fan power cable from the mounted fan to the mdi fan power connector on the board. Then return to pin position. Look for the gold arrow. It introduces a 66MHz, bit channel for the graphics controller to directly access main memory.

MSI K8MM-ILSR - motherboard - micro ATX - Socket 754 - K8M800 Series

To connect to the ATX power supply, make sure the plug of the power supply is inserted in the proper orientation and the pins are aligned. Please turn off the power and unplug the power cord before installing the CPU.

If the mainboard has a System Hardware Monitor chipset on-board, you must use a specially designed fan with speed sensor to take advantage of the CPU fan control.

Before inserting the power supply connector, always make sure that all components are installed properly to ensure that no damage will be caused. Memory modules can be installed in any combination as follows: Ms a community-based project which helps to repair anything. Hardware Setup Hardware Setup This chapter tells you how to install the CPU, memory modules, and expansion cards, as well as how to setup the jumpers on the mainboard.

Please note that any violation of the correct installation procedures may cause permanent damages to your mainboard.

Then push down the power supply firmly into the connector. AGP is an interface specification designed for the throughput demands of 3D graphics. While doing the installation, be careful in holding the components and follow the installation procedures. You can install either single- or double-sided modules in any order to meet your own needs.

Press the CPU down firmly into the socket and close the lever. Mount the fan on top of the heatsink. Meanwhile, read the documentation for the expansion card to make any necessary hardware or software settings for the expansion card, such as jumpers, switches or BIOS configuration. Otherwise, the Line-Out connector on the back panel will not function.

The plastic clip at each side of the DIMM slot will automatically close. Also, it provides the instructions on connecting 671 peripheral devices, such as the mouse, keyboard, etc. J9 Optional You can connect a joystick or game pad to this connector. You must configure second hard drive to Slave mode by setting the jumper accordingly.

Support For K8MM-ILSR | Motherboard - The world leader in motherboard design | MSI Global

The CPU can only fit in the correct orientation. You can plug the USB device directly into the connector. The third PCI slot supports 2 master devices. Position the heatsink onto the retention mechanism.

The gold arrow should point towards the lever pivot. Follow the instructions below to clear the data: Line In is used for external CD player, Tape player, or other audio devices. Overheating Overheating will seriously damage the CPU and system, always make sure the cooling fan can work properly to protect the CPU from overheating. When you are installing the CPU, make sure the CPU has a heat sink and a cooling fan attached on the top to prevent overheating.

Mic is a connector for microphones. IDE1 can connect a Master and a Slave drive. Press the two levers down to fasten Press down the fan until its four clips get wedged in the holes of the retention mechanism.